Detailed introduction of bending machine Ⅰ

Hydraulic bending machine comprises a bracket, a table and a clamping plate, the table is arranged on the bracket, the table is composed of a base and a pressing plate, the base is connected with the clamping plate through a hinge, the base is composed of a shell, a coil and a cover plate, the coil is arranged in the sag of the shell, the top of the sag is covered with a cover plate. In use, the wire is energized to the coil, and the force of the pressure plate is generated after the power is energized, so as to realize the clamping of the thin plate between the pressure plate and the base. Due to the use of electromagnetic force clamping, the plate can be made into a variety of workpiece requirements, and can be processed on the side wall of the workpiece.

SectionⅠlifting and installation

Hydraulic plate bending machine lifting and installation

1. The center of gravity of the hydraulic plate bending machine is high, and the front weight is light, so the center of gravity position must be paid attention to in the process of lifting and handling and installation, so as not to cause the machine turning accident. When lifting, the Angle of the lifting wire is as small as possible to ensure the accuracy of the machine tool is unchanged.

2. About hydraulic sheet metal bending machine, 2 columns in working mesa to gauge the benchmark level, vertical and horizontal direction shall be less than or equal to 1000:0.2, according to the foundation diagram pre-made, install the hydraulic sheet metal bending machine, based on the loaded anchor bolt at the same time, the final grouting, after being all cement solidification, set bolt, proofreading.

Hydraulic bending machine pressure debugging

1 hydraulic bending machine accounting pressure is based on the sheet tensile strength accounting. If you plate function is different, is the same as the accounting, but the force of the practical demand is different.

2 If the external factors are the same, it is only a problem of hydraulic bending machine. Two local adjustments can be made. One is to adjust the tensile strength of the panel in the system, and the other is to adjust the DA value in the system setting.

Related product links

Fiber Laser Cutting Machine